Minneapolis-St. Paul, MN-WI (1888PressRelease)
April 10, 2008 - Barsco, LLC announces the introduction of BUMP-A-RACK, a simple, convenient, inexpensive “when you need it” vehicle roof protection bumper you can installed or removed in seconds. No tools required. Just put in place and you are ready to load. BUMP-A-RACK is the solution for all vehicles: automobiles, pickups, vans, SUVs. Ideal for those who do not need or want the expense of permanent roof racks.
Made of molded polyurethane foam with three encapsulated magnets to hold it in place during loading, BUMP-A-RACK is light, flexible and tough and is easy to store behind or under the seat or in the trunk.
No special straps required. Use standard tie-down straps or bungee cords for most vehicles. Ratchet tie-down straps are suggested for pickups.
Available in single and double pack at auto accessory stores, home improvement stores, outdoor outfitters, water sport and surf shops. BUMP-A-RACK can also be purchased online at www.bump-a-rack.com. Single pack: $29.95, double pack, $54.95 plus shipping.
BUMP-A-RACK makes a great gift for the do-it-yourselfer, contractor, gardener, camper, surfer, paddle boarder, canoer, kayaker, just about anyone who carries “stuff.”
BUMP-A-RACK is manufactured by Barsco LLC, a specialty polyurethane molder that also manufactures the Load Assist Block, a product used by truckers to meet Federal Statute 393.100 for tying down uneven truck loads.
###
